14
While the individual temperature and time values are indicated, symbol A (Auto) is glowing.
Apart from that, the readout of the display will be in line with that shown during the setting
procedure.
7.7 Pause function in Automatic Operation
Any activated function can be interrupted by briefly pressing the Start/Stop Button [►■].
This will prompt deactivation of any heating functions and interruption of any operating times
probably effective. The interruption is signalled by the symbol “A” in the upper left-hand corner of
the display blinking. Depending on the respective programme step, the current temperature
around the meat probe and the operating time effectively remaining for the respective programme
step are indicated.
The programme will keep interrupted until the Start/Stop Button [►■] is briefly re-pressed to
resume the function, or the programme function is quit by keeping the Start/Stop Button [►■]
pressed for 2 seconds.
8. Troubleshooting and error display
8.1 Meat probe is missing
If the meat probe is neither required for a function nor connected, the function will be started
nonetheless. The starting process will be accompanied by an audible signal with the “meat probe”
symbol blinking.
The meat probe is required for the following functions:
- Manual function: “combined top/bottom heat with meat probe”
- All automatic programmes
Choosing those functions, the oven will not power up until meat probe is recognised.
Fig.: Readouts indicating missing meat probe in both Manual and Automatic Operation
(“meat probe” symbol is blinking)
Connecting the meat probe will reset the alarm and set the function going.
The audible signal can be reset for 2 minutes by pressing any button once.
8.2 Excessive temperature around meat probe
When the upper sensor detects too excessive a temperature (T>230°) around the meat probe,
you will notice both an audible and a visual signal. In such a case, remove the meat probe.
Caution! Mind the danger of burns upon removal of the meat probe!
As the temperature drops, the audible signal will be reset automatically.
The audible signal can be reset for 2 minutes by pressing any button once.
8.3 Defective sensors to determine the oven temperature
When an improper value is detected by a temperature sensor (T<= 0°C or T>350°C), the
appropriate error code appears on the display (e.g. „Er01“).
In such a case, please approach our customer service by dialling (+49) 9851 / 57 58-32 and give a
description of the fault.
8.4 Overheating protection
The BGO 1600/E additionally features a thermal overheating protection facility, interrupting the
voltage supply inside the appliance when the tolerable temperature limit is exceeded. After the
appliance has cooled down, the voltage supply will be restored automatically.
At this stage, the timer will be in the switch-on mode.
(32 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern